Clicking on Validate, will check your model against the Project Information Parameters previously set. Follow the 'Configure Model' and 'Configure Revisions' guides for details.

Validate will perform the following steps to highlighted Sheets:

Establish if the Sheet Record exists in Atvero already.
Establish if the Parameters conform with the Project Standard.
Enumerate current Drawing Title, Revit Revision, Atvero Revision, Status and Classification.
Set the next Atvero Revision based on the numerical sequence.
Check for a 'Pending Revision' and Pre-pend the Atvero.Revision Parameter to the Pending Revision Description.

Validate Title Block

Introduction